Nistune Type 4 Bedienungsanleitung

V1.6 TYPE #4 Hardware Installation – Type 4 boards (V1.6) (JECS 1990-2001 Engine Control Units) Copyright 2004 – 2014 Nis

Type 4 Hardware Installation Manual Page 9 of 21 • Soldering Tips and techniques Feed the tips of the ribbon cab

Type 4 Hardware Installation Manual Page 10 of 21 Now you can solder away. Ensure the solder flows right through. E

Type 4 Hardware Installation Manual Page 11 of 21 • Change ECU jumper settings Jumpers are used on the ECU to tell

Type 4 Hardware Installation Manual Page 12 of 21 ECU Jumper Illustrations R021 to R020 – found on top side

Type 4 Hardware Installation Manual Page 13 of 21 J932 to J933 - for Y33 6P5XX J031 to J030 – for A32 VQ30DE 199

Type 4 Hardware Installation Manual Page 14 of 21 • Check jumpers on NIStune board Most users will not need to ch

Type 4 Hardware Installation Manual Page 15 of 21 • Fit board to adaptor The NIStune board simply plugs onto the ad

Type 4 Hardware Installation Manual Page 16 of 21 • Fit board to ECU Place the Type 4 daughterboard inside the E

Type 4 Hardware Installation Manual Page 17 of 21 • Appendix A NIStune Board Jumper Settings Listing Fit Jumper

Type 4 Hardware Installation Manual Page 18 of 21 • Appendix B Tips/techniques for moving ECU jumpers The jumpers

Type 4 Hardware Installation Manual Page 1 of 21 INTRODUCTION Welcome to Nistune. The Nistune hardware and software

Type 4 Hardware Installation Manual Page 19 of 21 0603 size (small) Found on R34 and similar ECU’s. VER

Type 4 Hardware Installation Manual Page 20 of 21 Revision History DATE VERSION DESCRIPTION AUTHOR Aug08 1.1.1 In

Type 4 Hardware Installation Manual Page 2 of 21 IMPORTANT INFORMATION Nistune Developments has performed necessary m

Type 4 Hardware Installation Manual Page 3 of 21 TABLE OF CONTENTS • ECU covers removal ...

Type 4 Hardware Installation Manual Page 4 of 21 • ECU covers removal Tip : The screws that secure the covers wi

Type 4 Hardware Installation Manual Page 5 of 21 • Solder removal Using a de-soldering gun with a small tip car

Type 4 Hardware Installation Manual Page 6 of 21 Tips: The best way to de-solder the pads is to run a line of flux

Type 4 Hardware Installation Manual Page 7 of 21 Clean the row(s) of pads on both sides of the board with solvent and

Type 4 Hardware Installation Manual Page 8 of 21 • Fit Power Support Wires (for Dual Bank board only) Applies only